Wheel Bolt Replacement: Rear

Raise and support the vehicle (see LIFT AND SUPPORT POINTS ).
Remove the rear brake drum (see REAR BRAKE DRUM REPLACEMENT ).
Separate the wheel bolt (A) from the hub (B) using the ball joint remover (C), and keep the jaw (D) of ball joint remover squarely against the wheel bolt (see BALL JOINT REMOVAL ).
NOTE: If the angle of the remover against the wheel bolt is not vertical, readjust the ball joint remover by turning the head (E) of the adjusting bolt (F).

Fig 1: Identifying Wheel Bolt, Hub, Washers, & Adjusting Bolt
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Insert the new wheel bolt (A) into the hub (B) while aligning the splined surfaces (C) on the hub hole with the wheel bolt. Adjust the measurement (D) with the washers (P/N 94101-12800 or equivalent) (E), then install a nut (P/N 90304-SC2-000 or equivalent) (F) hand-tight.
NOTE:
- Before installing the new wheel bolt, clean the mating surfaces on the bolt and the hub.
- Degrease the area around the wheel bolt and the threaded section of the nut.
- Make sure the wheel bolt is exactly perpendicular to the hub disc surface.
- Do not install the nut and washers that have been used as tools on a vehicle.
  
  Fig 2: Identifying Wheel Bolt & Hub
  Courtesy of AMERICAN HONDA MOTOR CO., INC.
Tighten the nut until the wheel bolt is drawn fully into the hub. Do not exceed the maximum torque limit. Make sure there is no gap (G) between the bolt and the hub.
Torque limit:

108 N.m (11.0 kgf.m, 80 lbf.ft) max
Install the rear brake drum (see REAR BRAKE DRUM REPLACEMENT ).
NOTE:
- If you cannot tighten the wheel nut to the specified torque value when installing the wheel, replace the rear hub bearing unit as an assembly.
- Before installing the wheel, clean the mating surfaces of the brake disc/drum and the inside of the wheel.