LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2010 >> Fit Sport, Standard >> Repair and Diagnosis >> Suspension >> Rear Suspension >> Front And Rear Suspension - Inspection And Adjustment >> Wheel Bolt Replacement >> Front

Wheel Bolt Replacement: Front

  1. Raise and support the vehicle.
  2. Remove the front hub (see KNUCKLE/HUB/WHEEL BEARING REPLACEMENT ).
  3. Separate the wheel bolt (A) from the hub (B) using a hydraulic press. Support the hub with hydraulic press attachments (C) or equivalent tools.
    Fig 1: Identifying Wheel Bolt
    G05959058Courtesy of AMERICAN HONDA MOTOR CO., INC.
    NOTE:
    • Before installing the new wheel bolt, clean the mating surfaces on the bolt and the hub.
    • The graphic shows a front hub.
  4. Insert the new wheel bolt into the hub while aligning the splined surfaces on the hub hole with the wheel bolt.
    NOTE:
    • Before installing the new wheel bolt, clean the mating surfaces on the bolt and the hub.
    • Degrease the area around the wheel bolt.
    • Make sure the wheel bolt is installed vertically in relation to the hub disc surface.
  5. Install the wheel bolt using a hydraulic press until the wheel bolt shoulder is fully seated.
  6. Install the front hub (see KNUCKLE/HUB/WHEEL BEARING REPLACEMENT ).
    NOTE: If you cannot tighten the wheel nut to the specified torque value when installing the wheel, replace the front hub or rear hub bearing unit as an assembly.
scientia non olet · About LEMON Manuals