Transfer Output Shaft Bearing Removal/Installation (M/T)

Transfer Output Shaft Bearing Removal/Installation

Special Tools Required

- Driver Handle, 40 mm I.D. 07746-0030100
- Bearing Driver Attachment, 35 mm I.D. 07746-0030400

NOTE: Coat all parts with MTF during reassembly.

1. Remove the 62 mm tapered roller bearing (A) from the transfer output shaft (B) using a commercially available bearing separator (C), an adapter (D), and a press.






2. Install a new 62 mm tapered roller bearing (A) on the transfer output shaft (B) using the 40 mm I.D. driver handle (C), the 35 mm I.D. inner driver (D), and a press.