Washer Motor Test

Washer Motor Test

1. Remove the right inner fender.

- '07-08 models
- '09-11 models Service and Repair

2. Disconnect the 2P connectors (A) from the washer motors.





3. Test the motor by connecting battery power to terminal No. 1 and ground to terminal No. 2 of the washer motor. The motor should run.

- If the motor does not run or fails to run smoothly, replace it.
- If the motor runs smoothly, but little or no washer fluid is pumped, check for a disconnected or blocked washer hose, or a clogged pump outlet in the motor.