A/T Secondary Shaft Ball Bearing, Idler Gear Removal And Installation (A/T)

A/T Secondary Shaft Ball Bearing, Idler Gear Removal and Installation

Special Tools Required

- Bearing Driver Attachment, 42 mm 07QAD-P0A0100

Removal

Place a spacer (A) on the secondary shaft (B), and set a puller (C) under the idler gear (D), then remove the idler gear and ball bearing (E).






Installation

Install the idler gear (A) on the secondary shaft (B), and install the ball bearing (C) over the idler gear using the 42 mm I.D. attachment and a press.