Transmission Fluid Pressure Switch B (3RD Clutch) Replacement

Transmission Fluid Pressure Switch B (3rd Clutch) Replacement

1. Disconnect the transmission fluid pressure switch B (3rd clutch) connector, and remove transmission fluid pressure switch B (3rd clutch) (A) and the sealing washer (B).





2. Install new transmission fluid pressure switch B (3rd clutch) with a new sealing washer, and tighten transmission fluid pressure switch B (3rd clutch) to the specified torque by turning the metal part, not the plastic part.

3. Check the connector for corrosion, dirt, or oil, and clean or repair if necessary, then connect the connector securely.