Air Bag Deactivation Indicator: Service and Repair

Passenger's Airbag Cutoff Indicator Replacement

1. Remove the center panel Dashboard Center Panel Removal/Installation.

2. Disconnect the 4P connector (A) from the passenger's airbag cutoff indicator (B).





3. Push out the passenger's airbag cutoff indicator from behind the center panel (C), then remove it.

4. Reinstall the parts in the reverse order of removal.

5. After installing the passenger's airbag cutoff indicator, confirm proper SRS operation:

- Clear the DTC memory.
- Turn the ignition switch to ON (II), and check that the SRS indicator comes on for about 6 seconds and then goes off.