Transmission Fluid Pressure Switch A (2ND Clutch) Replacement

Transmission Fluid Pressure Switch A (2nd Clutch) Replacement

1. Remove the air cleaner assembly Service and Repair.

2. Disconnect the transmission fluid pressure switch A (2nd clutch) connector, and remove transmission fluid pressure switch A (2nd clutch) and the sealing washer (B).





3. Install new transmission fluid pressure switch A (2nd clutch) with a new sealing washer, and tighten transmission fluid pressure switch A (2nd clutch) to the specified torque by turning the metal part, not the plastic part.

4. Check the connector for corrosion, dirt, or oil, and clean or repair if necessary, then connect the connector securely.

5. Install the air cleaner assembly Service and Repair.