Trunk / Liftgate Position Sensor: Testing and Inspection

Hatch Latch Switch Test

1. Open the hatch and remove the hatch trim panel Interior Trim Removal/Installation - Hatch Area.

2. Disconnect the 2P connector (A) from the hatch latch switch (B).





3. Check for continuity between hatch latch switch 2P connector terminals No. 1 and No. 2.

- There should be continuity with the hatch open.
- There should be no continuity with the hatch closed.

4. If the continuity is not as specified, replace the hatch latch switch Hatch Latch Replacement.