Component Tests and General Diagnostics

Audio Remote Switch Test/Replacement

SRS components are located in this area. Review the SRS component locations Locations, and the precautions and procedures Service and Repair in the SRS before doing repairs or service.

'09-11 models

1. Remove the driver's airbag assembly.

2. Remove the two screws and cover (A) from the steering wheel.





3. Remove the two screws from the audio remote switch (B).

4. Disconnect the 5P connector from the audio remote switch.

5. Measure the resistance between terminals No. 1 and No. 3 in each switch position according to the table.





6. If the resistance is not as specified, replace the audio remote switch.