Ex-11

SRS DTC Troubleshooting: Ex-11

DTC Ex-11 ("x" can be 0 thru 9 or A thru F):

Control Operation Recorded

NOTE:

- Before doing this troubleshooting procedure, review SRS Precautions and Procedures Service and Repair and General Troubleshooting Information Reading and Clearing Diagnostic Trouble Codes.
- Control operation recordings occur during a vehicle collision. In some collisions and airbag or tensioner may deploy. Refer to Component Replacement/Inspection After Deployment Service and Repair for a complete list of other pars that must also be replaced.

1. Clear the DTC memory.

2. Turn the ignition switch to ON (II), then wait for 10 seconds.

3. Read the DTC.

Is DTC Ex-11 indicated?

YES -

Faulty SRS unit; replace the SRS unit SRS Unit Replacement.�

NO -

Intermittent failure, the system is OK at this time. Go to Troubleshooting Intermittent Failures. If another DTC is indicated, troubleshoot the DTC.�