How to Clear DTCs Using the HDS (Honda Diagnostic System)

How to Clear DTCs Using the HDS (Honda Diagnostic System)
1. With the ignition switch to LOCK (0), connect the HDS to the data link connector (DLC) (A) located under the driver's side of the dashboard.





2. Turn the ignition switch to ON (II).
3. For '06-08 models; make sure the HDS communicates with the vehicle and the EPS control unit. If it doesn't, troubleshoot the DLC circuit.
4. Clear the DTC(s) by following the screen prompts on the HDS.

NOTE: See the HDS Help menu for specific instructions.