LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2008 >> Element 2WD L4-2.4L >> Repair and Diagnosis >> Transmission and Drivetrain >> Sensors and Switches - Transmission and Drivetrain >> Sensors and Switches - A/T >> Fluid Pressure Sensor/Switch >> Service and Repair >> 3RD Clutch Transmission Fluid

3RD Clutch Transmission Fluid

3rd Clutch Transmission Fluid Pressure Switch Replacement

1. Disconnect the 3rd clutch transmission fluid pressure switch connector, and remove the 3rd clutch transmission fluid pressure switch.
2. Install the new 3rd clutch transmission fluid pressure switch (A) with a new sealing washer (B). Tighten the switch to the specified torque on the metal part, not the plastic part.





3. Check the connector for rust, dirt, or oil, and clean if necessary, then connect the connector securely.
scientia non olet · About LEMON Manuals