Parking Brake Warning Switch: Testing and Inspection

Parking Brake Switch Test

NOTE: If both the ABS/VSA indicator and the brake system indicator come on at the same time, check the VSA system first.

1. Remove the center console: Except SC model.
2. Disconnect the parking brake switch connector (A) from the parking brake switch (B).

NOTE: The illustration shows except SC model.





3. Check for continuity between the switch terminal (C) and body ground.

^ With the parking brake lever pulled, there should be continuity.
^ With the parking brake lever released, there should be no continuity.

NOTE: If the parking brake switch and the fluid level switch are OK, but the brake system indicator does not function, do the gauge control module test.

4. Connect the parking brake switch connector to the parking brake switch.
5. Install the center console.