DTC B1157: Gauge Control Module Lost Communication with MICU (MICU Message); DTC B1159: Gauge Control Module Lost Communication with MICU (DOORSW Message)
NOTE:
If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A (see TROUBLESHOOTING - B-CAN SYSTEM DIAGNOSIS TEST MODE A
).
- Clear the DTCs with the HDS.
- Turn the ignition switch OFF, and then back ON (II).
- Wait for 6 seconds or more.
- Check for DTCs with the HDS.
Are DTCs B1157 and/or B1159 indicated?
YES - Go to step 5.
NO - Intermittent failure. The gauge control module is OK at this time. Check for loose or poor connections.
- Check for DTCs with the HDS.
Are DTCs B1055, B1057, B1105, B1106, and B1255 also indicated?
YES - Go to MICU input test (see MICU INPUT TEST ).
NO - Go to gauge control module input test (see GAUGE CONTROL MODULE INPUT TEST ).