Checking the Front Passenger's Weight Sensors After A Vehicle Collision

Checking the Front Passenger's Weight Sensors after a Vehicle Collision

1. Position the front passenger's seat to the rear most position, adjust the recliner to the most forward position. Do not move the seat from this position.




2. Device the vehicle, accelerate to 20 mph (36km/h), then stop on the ground.
3. Make sure the ignition switch is OFF.
4. Connect the HDS to the DLC (A).
5. Turn the ignition switch ON (II).
6. From the SRS inspection menu, select Seat Weight Sensor, then Misc Test, then "SEAT OUTPUT CHK." and follow the prompts until the ODs operation check has completed.