DTC 65

DTC 65: Brake Fluid Level

1. Check the brake fluid level.
Is the level correct?
YES - Go to step 2.
NO - Check for leaks in the brake system. If no leaks are found, inspect the brake lining and replace any worn brake pads.

2. Disconnect the gauge control module connector B (36P), and brake fluid level switch connector.
3. Check for continuity between terminal No. 4 of the gauge control module connector B (36P) and body ground.





Is there continuity?
YES - Repair short to body ground in the wire between the gauge control module connector B and the brake fluid level switch.
NO - Go to step 4.

4. Check the brake fluid level switch.
Is the switch OK?
YES - Do the troubleshooting for the gauge control module.
NO - Replace the brake fluid level switch.