LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2007 >> Fit L4-1.5L >> Repair and Diagnosis >> Sensors and Switches >> Sensors and Switches - Restraints and Safety Systems >> Impact Sensor >> Service and Repair >> Front Impact Sensor Replacement

Front Impact Sensor Replacement

Front Impact Sensor Replacement

Removal

1. Disconnect the negative cable from the battery, and wait at least 3 minutes before beginning work.
2. Disconnect the driver's airbag 4P connector, the front passenger's airbag 4P connector, both seat belt tensioner 4P connectors, and both seat belt outer lap tensioner 2P connectors.
3. Remove the front bumper.




4. Disconnect the engine compartment wire harness 2P connector (A). Using a TORX T30 bit, remove the TORX bolts (B), then remove the front impact sensor (C).

Installation




1. Install the new front impact sensor with a new TORX bolts (A), then connect the engine compartment wire harness 2P connector (B) to the front impact sensor (C).
2. Reconnect the negative cable to the battery.
3. After installing the front impact sensor, confirm proper system operation: Turn the ignition switch ON (II); the SRS indicator should come on for about 6 seconds and then go off.
4. Reinstall all removed parts.
scientia non olet · About LEMON Manuals