LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2007 >> Fit Base, Standard >> Repair and Diagnosis >> Body & Frame >> Exterior/Interior Trim >> Dashboard >> Instrument Visor Removal/Installation

Instrument Visor Removal/Installation

NOTE:
  • Do not pry the visor or panel surface with any tools to prevent damage.
  • Take care not to scratch the dashboard and related parts.
  1. Tilt the steering column down.
  2. Remove the instrument panel (A):
    1. Gently pull out along the bottom to release the hooks (B), and ribs (C) from the clips (D) of the instrument lower visor (E).
    2. Gently pull out the upper portion of the panel to detach the hooks (F) and clips (G, H).
    Fig 1: Identifying Instrument Panel Fastener Clips
    G05456251Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Remove the instrument lower visor (A):
    1. Remove the screws (B).
    2. Gently pull out along the top to release the clips (C).
      3. Fig 2: Identifying Instrument Lower Visor Screws And Clips
      G05456252Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Remove the screws, then remove the instrument upper visor (A).
    Fig 3: Identifying Instrument Upper Visor Screws
    G05456253Courtesy of AMERICAN HONDA MOTOR CO., INC.
  5. Install the visors and panel in the reverse order of removal. Push the clip portions into place securely.
scientia non olet · About LEMON Manuals