Rear Crankshaft Main Bearing Seal: Service and Repair

Transmission End Crankshaft Oil Seal Installation - In Car

Special Tools Required
^ Driver 07749-0010000
^ Oil seal driver attachment 9607ZAD-PNAA100

1. Clean and dry the crankshaft oil seal housing.
2. Apply a light coat of multipurpose grease to the crankshaft and to the lip of the seal.





3. Use the special tools to drive a new oil seal squarely into the engine block to the specified installed height.
4. Measure the distance between the engine block (A) and crankshaft oil seal (B).