Special Tools Required

KTC trim tool set SOJATP2014

NOTE:

Take care not to scratch the dashboard and related parts.
Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.
Be very careful not to bend the trim.

Open the upper glove box.
Gently pry up on the dashboard center panel (A) to release the clips.

Fig 1: Prying Up On Dashboard Center Panel To Release Clips
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Pry up on the outside edge of the dashboard center panel (A) very carefully to detach the clips (B, C), then remove the panel.

Fig 2: Prying Up On Outside Edge Of Dashboard Center Panel To Detach Clips
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Disconnect the hazard warning switch/passenger's airbag off indicator connector (D), climate control unit connector (E), and interior lights switch connector (F).
If necessary, remove the screws securing the driver's center vent (A), then separate it from the dashboard center panel (B).

Fig 3: Removing Driver's Center Vent
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the panel in the reverse order of removal, and note these items:
- Make sure all connectors are plugged in properly.
- Replace any damaged clips.
- Push the clips and hooks into place securely.