Shift Solenoid Valve A and C Test

Shift Solenoid Valve A and C Test





1. Connect the HDS to the DLC (A).
2. Choose Shift Solenoid A and C in Miscellaneous Test Menu on the HDS.
3. Check that the shift solenoid valve A and C operates with the HDS.
^ If a clicking sound is heard, the solenoid is OK.
^ If no clicking sound is heard, go to step 4.





4. Disconnect the shift solenoid valve A (black) and C (brown) connectors.
5. Measure the shifts 41snoid valve A and C resistance at each solenoid valve connector.
Standard: 12 - 26 Ohms
6. Replace shift solenoid valve A or C if the resistance is out of standard.
7. If the resistance is within the standard, connect the No. 2 terminal of the shift solenoid valve A or C connector to the battery positive. terminal and connect the No. 1 terminal to the battery negative terminal. A clicking sound should be heard. Replace shift solenoid valve A or C if no clicking sound is heard.