Special Tools Required

KTC trim tool set SOJATP2014

NOTE:

Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.
Take care not to scratch the dashboard and related parts.
Put on gloves to protect your hands.

Open the front door, and remove the dashboard side cover (A).
1. -1 Gently pull out along the front edge to release the hooks (B).
2. -2 Gently pull out on the side cover to release the hooks (C), then remove the side cover.
Fig 1: Removing Dashboard Side Cover
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Push the bottom hook (A) back by hand, and pull out the bottom of the outer panel.

Fig 2: Pushing Bottom Hook Back
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Gently pry up on the driver's dashboard outer panel (A) to detach the clips and release the hook (B), then pull out the panel.

Fig 3: Prying Driver's Dashboard Outer Panel To Detach And Release Hook
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Disconnect the moonroof switch connector (C), power sliding door main switch connector (D), adjustable pedal switch connector (E), then remove the panel.
Install the outer panel in the reverse order of removal, and note these items:
- Make sure each connector is plugged in properly.
- Push the clips into place securely.