A/T Clutch Pressure Control Solenoid Valve C Replacement

A/T Clutch Pressure Control Solenoid Valve C Replacement
1. Disconnect the connector from A/T clutch pressure control solenoid valve C.





2. Remove A/T clutch pressure control solenoid valve C.
3. Clean the mounting surface and fluid passage of A/T clutch pressure control solenoid valve C and the transmission housing.
4. Install the 8 x 12 mm ATF feed pipe (A) with its filter side into the transmission housing.
5. Install the new gasket (B) in the mounting groove of the A/T clutch pressure control solenoid valve C body properly, then install them on the transmission housing. Do not pinch the gasket.
6. Check the solenoid connector for rust, dirt, or oil, and connect it securely.