Rear Seat Belt
Rear Seat Belt ReplacementNOTE: Check the rear seat belts for damage, and replace them if necessary. Be careful not to damage them during removal and installation.
Rear Seat Belt
1. Remove these items:
- Cargo floor lid
- Rear trim panel
- Rear seat
- Rear seat striker
2. Remove the lower anchor bolt.
3. Remove the rear side trim panel.
4. Remove the quarter pillar trim.
5. Remove the upper anchor bolt (A).
6. Remove the retractor bolt (A), then remove the rear seat belt (B) and retractor (C).
7. If necessary, remove the seat belt protector (D).
8. Install the seat belt in the reverse order of removal, and note these items:
- Apply liquid thread lock to the anchor bolts before reinstallation.
- Check that the retractor locking mechanism functions as described.
- Before installing the anchor bolts, make sure there are no twists or kinks in the seat belt.