Rear Brake Disc: Runout

Raise and support vehicle. Remove wheels. Remove brake pads. See REAR DISC BRAKE PADS under REMOVAL & INSTALLATION. Inspect disc surface for damage and cracks. Clean disc thoroughly, and remove all rust. Use wheel nuts and suitable flat washers to hold disc securely against hub, then mount a dial indicator to brake and measure runout at .4" (10 mm) from outer edge of disc.

Brake Disc Runout Service Limit - .004" (.10 mm)

If disc is beyond service limit, refinish brake disc. See DISC BRAKE SPECIFICATIONS .

NOTE: A new disc should be refinished if its runout is greater than .004" (.10 mm)