LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2003 >> Element 2WD L4-2.4L >> Repair and Diagnosis >> Transmission and Drivetrain >> Transmission Control Systems >> Actuators and Solenoids - Transmission and Drivetrain >> Actuators and Solenoids - A/T >> Pressure Regulating Solenoid >> Service and Repair >> Clutch Pressure Control Solenoid Valve B, and C Replacement

Clutch Pressure Control Solenoid Valve B, and C Replacement

A/T Clutch Pressure Control Solenoid Valve B, and C Replacement
1. Remove the air cleaner housing.
2. Disconnect the A/T clutch pressure control solenoid valves B and C connectors.





3. Remove the mounting bolts, harness clamp brackets (A), and A/T clutch pressure control solenoid valves B and C.
4. Remove the ATF joint pipes (D), O-rings (E), and gasket (F).
5. Clean the mounting surface and fluid passage of the transmission housing.
6. Install the new gasket on the transmission housing, and install the ATF joint pipes.
7. Install the new O-rings over the ATF joint pipes.
8. Install the new A/T clutch pressure control solenoid valves B and C, and harness clamp brackets.
9. Check the A/T clutch pressure control solenoid valves B and C connectors for rust, dirt, and oil, clean if needed, then connect them securely.
10. Install the air cleaner housing.

scientia non olet · About LEMON Manuals