Brake Shoes &/Or Pads: Remove & Replace
WARNING: This page is about the Insight Automatic CVT, which is a different variant/trim than selected.
Includes: Clean, lube and/or replace Brake Hardware as necessary. Adjust Brakes (where applicable).
Includes: Repack Wheel Bearings (where applicable).
DOES NOT include refinishing.| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| All,Both Axles | 2.2 | B | ||
| Front,Both Sides | 1.0 | B | ||
| Rear,Both Sides | 1.4 | B | ||
| Combination Procedure: CALIPER: Overhaul: Includes: Bleed Brake System. | ||||
| One | 0.7 | B | ||
| Combination Procedure: CALIPER: Replace: Includes: Bleed Brake System. | ||||
| One | 0.5 | B | ||
| Combination Procedure: DISC ROTOR: Remove and Install for Refinishing: This operation does not apply to drive axles. If on vehicle refinishing is not possible use appropriate repair operation. | ||||
| Not Applicable. | B | |||
| Combination Procedure: DISC ROTOR: Replace: | ||||
| Front | Not Applicable. | B | ||
| Combination Procedure: WHEEL BEARING: Repack: | ||||
| FWD | Refer to Front Wheel Bearing - R&R. | B | ||
| Combination Procedure: WHEEL BEARING: Replace: | ||||
| FWD, Front | Refer to Front Wheel Bearing - R&R. | B | ||
| Combination Procedure: WHEEL CYLINDER: Overhaul: | ||||
| Off Vehicle,One | 0.5 | B | ||
| On Vehicle,One | 0.3 | B | ||
| Combination Procedure: WHEEL CYLINDER: Replace: | ||||
| One | 0.3 | B | ||
| Combination Procedure: WHEEL SEAL: Replace: | ||||
| Refer to Front Wheel Bearing - R&R. | B | |||