LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2002 >> Insight Automatic CVT >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc Brakes & Drum Brakes >> Testing & Inspection >> Rear Brake Disc >> Thickness & Parallelism

Thickness & Parallelism

Raise, support, and remove wheels. Remove brake pads. See REAR DISC BRAKE PADS  under REMOVAL & INSTALLATION. Using a micrometer, measure disc thickness at 8 points approx. 45° apart and 0.4" (10 mm) in from outer edge of disc. Replace brake disc if smallest measurement is less than the MAX. Refinishing limit. See DISC BRAKE SPECIFICATIONS  .

NOTE: This is the maximum allowable difference between thickness measurements.

If the disc is beyond the service limit for parallelism, refinish brake disc.

  1. Brake Disc Parallelism Standard -  0.0006" (0.015 mm)

If it is beyond service limit for refinishing, replace. See BRAKE DISC (FRONT & REAR)  under REMOVAL & INSTALLATION.

scientia non olet · About LEMON Manuals