LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2002 >> Insight Automatic CVT >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc Brakes & Drum Brakes >> Testing & Inspection >> Rear Brake Disc >> Runout

Rear Brake Disc: Runout

Raise and support vehicle. Remove wheels. Remove brake pads. See REAR DISC BRAKE PADS  under REMOVAL & INSTALLATION. Inspect disc surface for damage and cracks. Clean disc thoroughly, and remove all rust. Use wheel nuts and suitable flat washers to hold disc securely against hub, then mount a dial indicator to brake and measure runout at 0.4" (10 mm) from outer edge of disc.

  1. Brake Disc Runout Service Limit -  0.004" (.10 mm)

If disc is beyond service limit, refinish brake disc. See DISC BRAKE SPECIFICATIONS  .

NOTE: A new disc should be refinished if its runout is greater than 0.004" (0.10 mm)
scientia non olet · About LEMON Manuals