LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2002 >> Insight Automatic CVT >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc Brakes & Drum Brakes >> Testing & Inspection >> Front Brake Disc >> Runout

Front Brake Disc: Runout

Raise and support vehicle. Remove front wheels. Remove brake pads. See FRONT DISC BRAKE PADS  under REMOVAL & INSTALLATION. Inspect disc surface for damage and cracks. Clean disc thoroughly, and remove all rust. Use wheel nuts and suitable flat washers to hold disc securely against hub, then mount a dial indicator to brake and measure runout at 0.4" (10 mm) from outer edge of disc.

  1. Brake Disc Runout Service Limit (Except Insight) -  0.004" (.10 mm)
  2. Brake Disc Runout Service Limit (Insight) -  0.002" (.05 mm)

If disc is beyond service limit, refinish brake disc with an on-car brake lathe. See DISC BRAKE SPECIFICATIONS  .

NOTE: A new disc should be refinished if its runout is greater than service limit.
scientia non olet · About LEMON Manuals