Removal & Installation (CR-V)

Release engine wire harness clips on strut brace, and remove strut brace. On M/T models, remove clutch reservoir bracket from strut brace, and move it aside. DO NOT disconnect clutch hose from reservoir. On all models, remove reservoir cap and brake fluid from master cylinder reservoir. Remove brake fluid level sensor connector. Disconnect brake lines from master cylinder. Cover with shop towels to prevent spillage. Remove master cylinder mounting nuts and washers. Remove cylinder from brake booster. Be careful not to damage brake lines when removing. Remove rod seal from master cylinder. Install master cylinder in reverse order of removal.

NOTE: Replace all rubber parts with NEW ones whenever removed. Coat lip of new rod seal with recommended seal grease in master cylinder set. Install rod seal onto brake booster with its grooved side toward master cylinder. Check pushrod clearance before installing master cylinder, and adjust if necessary. See MASTER CYLINDER PUSHROD under ADJUSTMENTS. Check brake pedal height and free play.