LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2000 >> S2000 >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Gauges >> Gauge Assembly Replacement

Gauge Assembly Replacement

NOTE: For '06-09 models before replacing the gauge assembly, do the "Rewriting the ODO Data and Transferring the Maintenance Minder Data to a New Gauge assembly" (see REWRITING THE ODO DATA AND TRANSFERRING THE MAINTENANCE MINDER DATA TO A NEW GAUGE ASSEMBLY ).
  1. Lower the steering column, and remove the driver's airbag, the steering wheel, the steering column covers, the cable reel, and the combination switch assembly (see STEERING COLUMN REMOVAL AND INSTALLATION ).
  2. Remove the instrument panel (see INSTRUMENT PANEL REMOVAL/INSTALLATION ).
  3. Remove the screws (A) from the gauge assembly (B), and spread a protective cloth (C) on the steering column.
    Fig 1: Identifying Screws, Gauge Assembly And Protective Cloth
    G06232344Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Disconnect the connectors (D), and remove the gauge assembly.
    NOTE: '04-09 models only have two connectors.
  5. Remove the screws and the gauge assembly brackets (A).
    Fig 2: Identifying Gauge Assembly Brackets
    G06232345Courtesy of AMERICAN HONDA MOTOR CO., INC.
  6. Install the gauge assembly in the reverse order of removal.
scientia non olet · About LEMON Manuals