How to End a Troubleshooting Session

WARNING: This page is about a different car, the 2004 Honda Odyssey, 2003 Honda Odyssey, and 2002 Honda Odyssey. However, it is still accessible from the selected car via links, so may be relevant.

This procedure must be done after any troubleshooting.

Turn the ignition switch OFF.
Connect the Scan Tool or the HDS to the DLC.
Turn the ignition switch ON (II).
Clear the DTC(s) with the Scan Tool or the HDS.
NOTE: You can also reset the memory by removing the No. 13 fuse in the passenger's under-dash fuse/ relay box for more than 10 seconds. If you do, you need to do the following:
- Get the customer's radio and navigation (if equipped) anti-theft code, and write down the radio and navigation presets.
- Enter the radio and navigation (if equipped) anti-theft code, reset the preset stations, and set the clock.
- Do the idle learn procedure (see PCM IDLE LEARN PROCEDURE ).
To verify that the problem is repaired, test-drive the vehicle for several minutes at speeds over 30 MPH (50 km/h) or under the same conditions as those indicated by the freeze data.