Parking Brake: Adjustment
NOTE:
After servicing the rear brakes shoes, loosen the parking brake adjusting nut, start the engine, and press the brake pedal several times to set the self-adjusting brake before adjusting the parking brake.
- Block the front wheels, then raise the rear of the vehicle, and make sure it is securely supported.
- Remove the console. See Figure .
- Pull the parking brake lever up one click.
- Tighten the adjusting nut until the parking brakes drag slightly when the rear wheels are turned. See Fig 1 .
- Release the parking brake lever fully, and check that the parking brakes do not drag when the rear wheels are turned. Readjust if necessary.
- Make sure the parking brakes are fully applied when the parking brake level is pulled fully.
- Reinstall the console. See Figure .