LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2000 >> Civic LX, Standard, S40 >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc & Drum >> Removal & Installation >> Brake Drum >> Removal & Installation

Removal & Installation

  1. Raise and support vehicle. Remove rear wheels. Loosen parking brake. Pull brake drum off hub.
  2. Inspect lining friction surface of drum for grooves, excessive wear and damage. Using an inside micrometer, measure Inner Diameter (I.D.) of brake drum. If I.D. is not within specification, replace brake drum. See DRUM BRAKE SPECIFICATIONS  table.
  3. Resurface drum when new linings are installed. Replace drum if specification is exceeded. To install, reverse removal procedure.
scientia non olet · About LEMON Manuals