Installation (All Models)
NOTE:
Ensure vehicle weight is supported on strut assembly before tightening lower strut mounting bolt to specification.
- Lower rear suspension, and place strut assembly in its original position. Loosely install lower strut mounting bolt. Loosely install upper strut mounting nuts.
- Raise rear suspension so strut assembly supports vehicle weight. Loosely install strut mounting. Reverse removal procedure for remaining components. Raise rear suspension until weight of car is on strut. Tighten fasteners to specification. See TORQUE SPECIFICATIONS . Install strut cap (if equipped). Check rear wheel alignment and adjust as necessary. See SPECIFICATIONS & PROCEDURES in WHEEL ALIGNMENT article.