LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2000 >> CR-V SE, Standard >> Repair and Diagnosis >> Suspension >> Front Suspension >> Front Suspension System >> Removal & Installation >> Wheel Bearing >> Installation

Wheel Bearing: Installation

  1. Press NEW bearing into knuckle using the old bearing and Support Base (07695-SD90100), Attachment (07965-SA00600) and Driver (07749-0010000). On Odyssey use Support Base (07965-SD90100) and Attachment (07948-SB00101). Install snap ring in knuckle groove.
  2. Install splash guard, and invert knuckle. On Accord, CR-V and Prelude, press knuckle/bearing assembly onto hub using Support Base (07695-SD90100), Driver (07749-0010000) and Attachment (07965-SA00600. On Civic, use Support Base (07965-SD90100), Driver (079497-0010000) and Attachment (07947-6340201). On Odyssey, use Support Base (07965-SD90100), Driver (07749-0010000) and Attachment (07746-0010500). See Fig 1. To complete installation, reverse removal procedure.
Fig 1: Pressing Knuckle/Bearing Assembly Onto Hub (Typical)
G96B20975Courtesy of AMERICAN HONDA MOTOR CO., INC.
scientia non olet · About LEMON Manuals