LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2000 >> CR-V SE, Standard >> Repair and Diagnosis >> General Information >> Restraints >> Air Bag Deactivation Procedures >> TOYOTA >> Disabling & Activating Air Bag System >> Disabling Air Bag System (Celica)

Disabling Air Bag System (Celica)

  1. Obtain radio anti-theft protection code from owner prior to servicing vehicle or deactivate radio anti-theft function before disconnecting vehicle battery.
  2. Place front wheels in straight-ahead position. Turn ignition switch to LOCK position. Disconnect and shield negative battery cable. Wait at least 90 SECONDS before working on vehicle.
  3. Remove steering column lower cover. See Figure. Disconnect driver air bag module Yellow 2-pin connector. Air bag connector terminals are automatically shorted together. See Figure.
  4. Remove glove box and lower finish panel. Unplug passenger air bag module Yellow 2-pin connector, accessible through glove box opening. Air bag connector terminals are automatically shorted together.
  5. Unplug left and right side air bag module Yellow 2-pin connectors. Connectors are located under front edge of each front seat.
  6. Unplug left and right seat belt pretensioner Yellow 2-pin connectors. For access to seat belt pretensioner connectors, remove door lower scuff plate. Pry back front lower corner of rear quarter trim panel. Connector terminals are automatically shorted together.
scientia non olet · About LEMON Manuals