LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2000 >> CR-V SE, Standard >> Repair and Diagnosis >> General Information >> Restraints >> Air Bag Deactivation Procedures >> HONDA >> Disabling & Activating Air Bag System >> Activating Air Bag System (Accord)

Activating Air Bag System (Accord)

NOTE: To reconnect front SRS connectors, push sleeve-side connector half toward pawl-side connector half without touching sleeve. As connector halves are pressed together, pawl will push sleeve back. When connector halves are completely connected, pawl will release spring-loaded sleeve and connector will lock.
  1. Ensure ignition is OFF and negative battery cable is disconnected. Connect 2-pin driver-side air bag connector.
  2. Connect 4-pin passenger air bag connector. Install glove box. Connect driver and passenger side impact air bag module 2-pin connectors under seats.
  3. Reconnect negative battery cable. Check SRS indicator light to ensure system is functioning properly. See SYSTEM OPERATION CHECK . Reprogram radio frequencies.
scientia non olet · About LEMON Manuals