Activating Air Bag System (3.2TL)

NOTE: To reconnect front SRS connector, push sleeve-side connector half toward pawl-side connector half without touching sleeve. As connector halves are pressed together, pawl will push sleeve back. When connector halves are completely connected, pawl will release spring-loaded sleeve and lock connector.

Ensure ignition is OFF and negative battery cable is disconnected. Connect 2-pin driver-side air bag connector to cable reel connector. Install access panel under steering wheel.
Connect 2-pin passenger air bag connector to SRS harness connector. Install glove box. Connect driver and passenger side impact air bag module 2-pin connectors under seats.
Ensure ignition is off. Connect negative battery cable. Ensure air bag system is functioning properly. See SYSTEM OPERATION CHECK . Reset radio anti-theft code and preset radio frequencies.

Fig 1: Disconnecting Front Air Bag Spring-Loaded Locking Connector (Acura)

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Fig 2: Disconnecting Side Air Bag Spring-Loaded Locking Connector (Acura)

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Fig 3: Disabling Driver Air Bag (Acura)

Fig 4: Disabling Passenger Air Bag (3.2TL)

Fig 5: Disabling Side Air Bags (Acura)