LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2000 >> CR-V SE, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Transmission Diagnosis - MDLA & MDMA) >> Removal & Installation >> Vehicle Speed Sensor >> Removal & Installation

Removal & Installation

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect harness connector from VSS. Remove bolt and vehicle speed sensor.
  2. To install, reverse removal procedure using NEW "O" ring. Install and tighten bolt to 18 ft. lbs. (24 N.m).
scientia non olet · About LEMON Manuals