LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2000 >> CR-V SE, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Transmission Diagnosis - MDLA & MDMA) >> Removal & Installation >> A/T Gear Position Switch >> Removal

A/T Gear Position Switch: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Turn ignition off. Apply parking brakes. Block both rear wheels. Raise and support front of vehicle. Place transaxle in Neutral. Disconnect A/T gear position switch harness connector. See Figure.
  2. Remove harness connector clamp and switch cover. Remove switch from control shaft.
scientia non olet · About LEMON Manuals