Clearing Diagnostic Trouble Codes
WARNING: This page is about a different variant/trim than selected.
NOTE:
Before clearing DTCs, obtain radio anti-theft code from customer. Note radio preset stations, as radio stations and clock setting will be cleared. Radio anti-theft code must be reset for radio operation.
- Once repairs have been performed, DTCs must be cleared from PCM memory. A/T control system memory can be cleared 2 ways: DTCs can be cleared using scan tool. Follow scan tool manufacturer's instructions. To clear DTCs without using scan tool, go to next step.
- Once repairs have been performed, DTCs must be cleared from PCM memory. Ensure ignition is off. Remove BACK-UP fuse (7.5 amp) from engine compartment fuse/relay box for at least 10 seconds. This will clear PCM memory.
- Reinstall fuse. To re-enter radio anti-theft code, turn radio on. When the word CODE is displayed on radio, re-enter radio anti-theft code by using the radio station preset buttons. Reset clock and radio stations.