LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2000 >> CR-V SE, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Transmission Diagnosis - MDLA & MDMA) >> Description & Operation >> Pcm Input Devices >> Service Check Connector

Service Check Connector

WARNING: This page is about a different variant/trim than selected.

Service check connector is used to retrieve flash codes (without scan tool) for transaxle electronic control system diagnosis. When jumper wire is installed between service check connector terminals, an input is delivered to PCM to display flash codes on "D" indicator light. Service check connector is a 2-pin connector located near DLC. See Figure.

scientia non olet · About LEMON Manuals