LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2000 >> CR-V SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 9 (Engine Controls - Self-Diagnostics - 3.2L & 3.5L) >> Programming >> EEPROM Programming Procedure

EEPROM Programming Procedure

WARNING: This page is about a different car, the 2000 Isuzu VehiCROSS, 2000 Isuzu Trooper, 2000 Isuzu Rodeo, 2000 Isuzu Amigo, and 2000 Honda Passport. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Refer to latest Isuzu Technical Communication System (ITCS) information for reprogramming or flashing procedures.

Connect TECH II scan tool to DLC and retrieve information from PCM. Ensure that battery is fully charged. Turn ignition on. Ensure that Vehicle Interface Module cable connection is securely connected to DLC. Follow scan tool instructions to program EEPROM using latest software available from ITCS. If PCM fails to program, recheck PCM connections. Ensure that most recent ITCS information is being used. Reattempt to program PCM. If it still can not be programmed properly, replace PCM. Reprogram new PCM, then perform On-Board Diagnostic (OBD) System Check. See BASIC DIAGNOSTIC PROCEDURES article. Start engine and run for one minute. Use scan tool to check for any stored DTCs.

scientia non olet · About LEMON Manuals