LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2000 >> CR-V SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 9 (Engine Controls - Self-Diagnostics - 3.2L & 3.5L) >> Diagnostic Trouble Code Identification >> DTC P0401: EGR Flow Insufficient >> Diagnostic Procedure

Diagnostic Procedure

WARNING: This page is about a different car, the 2000 Isuzu VehiCROSS, 2000 Isuzu Trooper, 2000 Isuzu Rodeo, 2000 Isuzu Amigo, and 2000 Honda Passport. However, it is still accessible from the selected car via links, so may be relevant.
  1. Perform On-Board Diagnostic (OBD) System Check. See BASIC DIAGNOSTIC PROCEDURES article. Read and record FREEZE FRAME and/or FAIL RECORDS data for each DTC set. Go to next step.
  2. If DTC P1404 is also set, go to DTC P1404: EGR STUCK CLOSED . If DTC P1404 is not set, go to next step.
  3. Start engine. Using scan tool, monitor MAP signal. Quickly press throttle half way down and release. If scan tool value made an immediate large change, go to next step. If scan tool value does not make an immediate large change, replace MAP sensor.
  4. Inspect exhaust system for modifications or leaks. If a problem is found, repair as necessary and go to step  7. If a problem is not found, go to next step.
  5. Remove EGR valve and check pintle, valve and passages and adapter for excessive deposits or restriction. Check EGR valve gasket and pipes for leaks. If a problem is found, repair as necessary and go to step  7. If no problem is found, go to next step.
  6. Remove EGR inlet and outlet pipes from exhaust and intake manifolds. Inspect manifold EGR ports and pipes for blockage. If a problem is found, repair as necessary, then go to next step. If no problem is found, check for an intermittent problem. See DIAGNOSTIC AIDS .
  7. Read and record FAIL RECORDS data for DTC P0401. Clear DTCs. Start engine and monitor system information screen while moving connectors and wiring harnesses related to EGR valve. If scan tool displays DTC P0401 FAILED THIS IGN, go to last step completed in this DTC test. If scan tool does not display DTC P0401 FAILED THIS IGN, repair is complete.
scientia non olet · About LEMON Manuals