LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2000 >> CR-V SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 7 (Engine Controls - Self-Diagnostics - 2.2L) >> Diagnostic Trouble Code Identification >> DTC P1380: Abs DTC Rough Road Data Unusable >> Diagnostic Procedures

Diagnostic Procedures

WARNING: This page is about a different car, the 2000 Isuzu Hombre. However, it is still accessible from the selected car via links, so may be relevant.
  1. Perform On-Board Diagnostic II (OBD-II) system check. See ON-BOARD DIAGNOSTIC II (OBD-II) SYSTEM CHECK in SELF-DIAGNOSTICS - INTRODUCTION article. After performing OBD-II system check, go to next step.
  2. Install Tech 2 scan tool. Turn ignition on, with engine off. Using scan tool, check for ABS DTCs. If any ABS DTCs are set, go to next step. If no ABS DTCs are set, go to step  4.
  3. Repair ABS system as necessary. See appropriate ANTI-LOCK article in BRAKES. After repair, go to next step.
  4. Turn ignition on, with engine off. Using scan tool, review FREEZE FRAME data, and note parameters. Start engine and operate vehicle within conditions required for setting this DTC, and as close to conditions recorded in FREEZE FRAME as possible. If misfire DTC is set, go to next step. If misfire DTC did not set, go to step  9.
  5. If DTC P1380 also set, go to next step. If DTC P1380 did not set, go to step  7.
  6. If ABS DTC is also set, go to step 3)  . If ABS DTC is not set, go to step  8.
  7. Repair condition causing misfire as necessary. After repair, go to step  9.
  8. Replace PCM. Program replacement PCM using appropriate equipment. See PROGRAMMING . After repair is completed, go to next step.
  9. Using scan tool, select CLEAR INFO or CLEAR DTCS function to clear DTCs. Start engine and allow it to idle. Ensure engine is at normal operating temperature. Operate vehicle within conditions required for setting this DTC. Select SPECIFIC DTC function, then enter DTC P1380. If scan tool indicates TEST RAN AND PASSED, go to next step. If scan tool does not indicate TEST RAN AND PASSED, repeat step  2.
  10. If any other DTCs are set, diagnose DTCs as necessary. If no other DTCs are set, no problem is indicated at this time.
scientia non olet · About LEMON Manuals