LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2000 >> CR-V SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 7 (Engine Controls - Self-Diagnostics - 2.2L) >> Diagnostic Trouble Code Identification >> DTC P0601: Pcm Memory >> Diagnostic Procedures

Diagnostic Procedures

WARNING: This page is about a different car, the 2000 Isuzu Hombre. However, it is still accessible from the selected car via links, so may be relevant.
  1. Perform On-Board Diagnostic II (OBD-II) system check. See ON-BOARD DIAGNOSTIC II (OBD-II) SYSTEM CHECK in SELF-DIAGNOSTICS - INTRODUCTION article. After performing OBD-II system check, go to next step.
  2. Replace PCM. Program replacement PCM using appropriate equipment. See PROGRAMMING . After replacing PCM, go to next step.
  3. Install Tech 2 scan tool. Using scan tool, select CLEAR INFO or CLEAR DTCS function to clear DTCs. Start engine and allow it to idle. Ensure engine is at normal operating temperature. Operate vehicle within conditions required for setting this DTC. Select SPECIFIC DTC function, then enter DTC P0601. If scan tool indicates TEST RAN AND PASSED, go to next step. If scan tool does not indicate TEST RAN AND PASSED, repeat step  2.
  4. If any other DTCs are set, diagnose DTCs as necessary. If no other DTCs are set, no problem is indicated at this time.
scientia non olet · About LEMON Manuals