Accord & Prelude (Except Prelude With Automatic Torque Transfer System - ATTS)
WARNING: This page is about a different car, the 2001 Honda Prelude, 2001 Honda Odyssey, 2001 Honda Civic, 2001 Honda CR-V, and 2001 Honda Accord. However, it is still accessible from the selected car via links, so may be relevant.
- Raise and support vehicle. Remove lock nut on end of radius (strut) rod. See Fig 1 . Remove radius rod bolts and radius rod from lower control arm.
- Adjust caster angle by increasing or decreasing adjusting shims. On Prelude, a 1/8" (3.2 mm) thick shim changes caster angle by .67 degree (40 minutes). Caster angle can be adjusted a maximum of 1.33 degree (one degree, 20 minutes). On Accord, a 1/8" (3.2 mm) thick shim changes caster angle by .58 degree (35 minutes). Caster angle can be adjusted a maximum of 1.17 degree (one degree, 10 minutes). Install NEW lock nut. Tighten radius rod bolts and lock nuts to specification. See TORQUE SPECIFICATIONS .